![]() These are used to control the rotating direction of Motor A. If both the inputs are either HIGH or LOW the Motor A will stop. When one of them is HIGH and the other is LOW, Motor A will start rotating in a particular direction. ![]() If the 5V-EN jumper is removed, you need to connect it to the 5V power supply of the microcontroller. ![]() If the 5V-EN jumper is in place, this pin acts as output and can be used to power up a microcontroller or other circuitry (sensor). +5V pin supplies power for the switching logic circuitry inside the L298N IC. It needs to be connected to the power supply ground(negative). VCC pin is used to supply power to the motor. ![]() L298N Motor Driver Module Pin Diagram/Pinout/Pin configuration ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |